Reference Guide

1286 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
router rip
c e s
Enter the ROUTER RIP mode to configure and enable RIP.
Syntax
router rip
To disable RIP, enter no router rip.
Defaults
Disabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
To enable RIP, you must assign a network address using the network command.
Example
FTOS(conf)#router rip
FTOS(conf-router_rip)#
Related
Commands
show config
c e s
Display the changes you made to the RIP configuration. Default values are not
shown.
Syntax
show config
Command Modes
ROUTER RIP
Command
History
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
network Enable RIP.
exit Return to the CONFIGURATION mode.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810