Reference Guide

1294 | Remote Monitoring (RMON)
www.dell.com | support.dell.com
Defaults
No default behavior
Command Modes
CONFIGURATION INTERFACE (config-if)
Command
History
rmon collection statistics
c e s z
Enable RMON MIB statistics collection on an interface.
Syntax
rmon collection statistics {controlEntry integer} [owner name]
To remove RMON MIB statistics collection on an interface, use the
no rmon
collection statistics
{controlEntry integer} command.
Parameters
Defaults
No default behavior
Command Modes
CONFIGURATION INTERFACE (config-if)
Command
History
buckets number
(OPTIONAL) Enter the keyword buckets followed the number of
buckets for the RMON collection history group of statistics.
Bucket Range: 1 to 1000
Default: 50
interval seconds
(OPTIONAL) Enter the keyword interval followed the number of
seconds in each polling cycle.
Range: 5 to 3600 seconds
Default: 1800 seconds
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.1.1.0 Introduced for E-Series
controlEntry integer
Enter the keyword controlEntry to specify the RMON group of
statistics using a value. Then enter an integer value from 1 to 65535
that identifies the RMON Statistic Table. The integer value must be a
unique in the RMON Statistic Table.
owner name
(OPTIONAL) Enter the keyword owner followed by the owner
name to record the owner of the RMON group of statistics.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810