Reference Guide

1308 | Rapid Spanning Tree Protocol (RSTP)
www.dell.com | support.dell.com
Parameters
Defaults
No default behavior or values
Command Modes
SPANNING TREE (The prompt is “config-rstp”.)
Command
History
Related
Commands
disable
c e s
Disable RSTP globally on the system.
Syntax
disable
To enable Rapid Spanning Tree Protocol, enter
no disable.
Defaults
RSTP is disabled
Command Modes
CONFIGURATION RSTP (conf-rstp)
Command
History
Related
Commands
forward-delay
c e s
Configure the amount of time the interface waits in the Listening State and the
Learning State before transitioning to the Forwarding State.
Syntax
forward-delay seconds
description
Enter a description to identify the Rapid Spanning Tree (80 characters
maximum).
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
pre-7.7.1.0 Introduced
protocol spanning-tree rstp Enter SPANNING TREE mode on the switch.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 6.2.1.1 Introduced for E-Series
protocol spanning-tree rstp Enter the Rapid Spanning Tree mode