Reference Guide

1324 | Security
www.dell.com | support.dell.com
Defaults
None
Command Modes
CONFIGURATION
Command
History
privilege level (CONFIGURATION mode)
c e s
Change the access or privilege level of one or more commands.
Syntax
privilege mode
{level level command | reset command}
To delete access to a level and command, use the
no privilege mode level level command
command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
tacacs+ Use the TACACS+ protocol to perform authorization.
none Enter this keyword to apply no authorization.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
Version 6.1.1.0 Added support for RADIUS
mode
Enter one of the following keywords as the mode for which you are controlling
access:
•
configure for the CONFIGURATION mode
•
exec for the EXEC mode
•
interface for the INTERFACE modes
•
line for the LINE mode
•
route-map for the ROUTE-MAP
•
router for the ROUTER OSPF, ROUTER RIP, ROUTER ISIS and ROUTER
BGP modes.
level level Enter the keyword level followed by a number for the access level.
Range: 0 to 15.
Level 1 is the EXEC mode and Level 15 allows access to all CLI modes and
commands.
reset
Enter the keyword reset to return the security level to the default setting.
command
Enter the command’s keywords to assign the command to a certain access level.
You can enter one or all of the keywords