Reference Guide

134 | Control and Monitoring
www.dell.com | support.dell.com
Command
History
Example
FTOS#show processes switch-utilization
Switch fabric utilization 5Sec 1Min 5Min
------------------------------------------------------
3% 3% 3%
Usage
Information
An asterisk ( * ) in the output indicates a legacy card that is not support by the show
processes switch-utilization
command.
show rpm
c e
Show the current RPM status.
Syntax
show rpm [number [brief] | all]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
(E-Series)
FTOS#show RPM 0
-- RPM card 0 --
Status : active
Next Boot : online
Card Type : RPM - Route Processor Module (LC-EF-RPM)
Hardware Rev : 2.0
Num Ports : 1
Up Time : 36 min, 51 sec
Last Restart : reset
FTOS Version : 6.2.1.0
Jumbo Capable : yes
CP Boot Flash : A: 2.4.0.6 B: 2.4.0.7 [booted]
RP1 Boot Flash: A: 2.4.0.7 [booted] B: 2.4.0.5
RP2 Boot Flash: A: 2.4.0.7 [booted] B: 2.4.0.5
CP Mem Size : 536870912 bytes
RP1 Mem Size : 0 bytes
RP2 Mem Size : 0 bytes
Temperature : 49C
Power Status : PEM0: absent or down PEM1: up
Version 8.1.1.0 Introduced on E-Series ExaScale
E-Series original Command
number (OPTIONAL) Enter either zero (0) or 1 for the RPM.
all (OPTIONAL) Enter the keyword
all to view a table with information on all present
RPMs.
brief
(OPTIONAL) Enter the keyword brief to view an abbreviated list of RPM
information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
E-Series original Command