Reference Guide

Security | 1377
Parameters
Defaults
Not configured.
Command Modes
TRACE LIST
Related
Commands
source
Enter the IP address of the network or host from which the packets were sent.
mask
(OPTIONAL) Enter a network mask in /prefix format (/x).
any
Enter the keyword any to specify that all routes are subject to the filter.
host ip-address
Enter the keyword host followed by the IP address to specify a host IP
address.
operator
(OPTIONAL) Enter one of the following logical operand:
•
eq = equal to
•
neq = not equal to
•
gt = greater than
•
lt = less than
•
range = inclusive range of ports (you must specify two ports for the port
command parameter.)
port port Enter the application layer port number. Enter two port numbers if using the
range logical operand.
Range: 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination
Enter the IP address of the network or host to which the packets are sent.
count
(OPTIONAL) Enter the keyword count to count packets processed by the
filter.
byte
(OPTIONAL) Enter the keyword byte to count only bytes processed by the
filter.
log (OPTIONAL) Enter the keyword log to have the information kept in a
Trace-list log file.
order number
(OPTIONAL) Enter the keyword order followed by a number from 0 to 7 as
the order number.
deny Assign a trace list filter to deny IP traffic.
deny udp Assign a trace list filter to deny UDP traffic.