Reference Guide

1394 | Service Provider Bridging
www.dell.com | support.dell.com
Example
FTOS#conf
FTOS(conf)#interface vlan 2
FTOS(conf-if-vl-2)#vlan-stack compatible
FTOS(conf-if-vl-2)#member Gi1/2-3
FTOS(conf-if-vl-2)#protocol-tunnel stp
FTOS(conf-if-vl-2)#protocol-tunnel enable
Related
Commands
protocol-tunnel destination-mac
c e s
Overwrite the BPDU destination MAC address with a specific value.
Syntax
protocol-tunnel destination-mac xstp address
Parameters
Defaults
The default destination MAC is 01:01:e8:00:00:00.
Command Modes
CONFIGURATION
Command
History
Usage
Information
When VLAN-Stacking is enabled, no protocol packets are tunneled.
Related
Commands
protocol-tunnel enable
c e s
Enable protocol tunneling globally on the system.
Syntax
protocol-tunnel enable
To disable protocol tunneling, use the no protocol-tunnel enable command.
Version 8.2.1.0 Introduced on the C-Series, E-Series and E-Series ExaScale.
Version 7.4.1.0 Introduced
show protocol-tunnel Display tunneling information for all VLANs
stp
Change the default destination MAC address used for L2PT to another value.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced
show protocol-tunnel Display tunneling information for all VLANs