Reference Guide

Service Provider Bridging | 1395
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS must have the default CAM profile with the default microcode before you
enable L2PT.
protocol-tunnel rate-limit
c e s
Enable traffic rate limiting per box.
Syntax
protocol-tunnel rate-limit rate
To reset the rate limit to the default, use the no protocol-tunnel rate-limit rate
command.
Parameters
Defaults
75 Frames per second
Command Modes
CONFIGURATION
Command
History
Example
FTOS#
FTOS#conf
FTOS(conf)#protocol-tunnel rate-limit 1000
FTOS(conf)#
Related
Commands
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.4.1.0 Introduced
rate
Enter the rate in frames per second.
Range: 75 to 3000
Default: 75
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduced on the C-Series, E-Series Terascale, and E-Series ExaScale.
Maximum rate limit on E-Series reduced from 4000 to 3000.
Version 7.4.1.0 Introduced
show protocol-tunnel Display tunneling information for all VLANs
show running-config Display the current configuration.