Reference Guide

sFlow | 1401
Usage
Information
When sFlow is enable on an interface, flow sampling is done on any traffic going out
of the interface.
Related
Commands
sflow extended-gateway enable
e
Enable packing information on an extended gateway.
Syntax
sflow extended-gateway [extended-router] [extended-switch] enable
To disable packing information, use the no sflow extended-gateway [extended-router]
[
extended-switch] enable command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
The show sflow command displays the configured global extended information.
FTOS 7.8.1.0 and later enhances the sFlow implementation for real time traffic
analysis on the E-Series to provide extended gateway information in cases where the
destination IP addresses are learned by different routing protocols, and for cases
where the destination is reachable over ECMP.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
Note: Once a physical port is a member of a LAG, it will inherit the sFlow
configuration from the LAG port.
sflow enable (Global) Turn sFlow on globally
extended-router
Enter the keyword extended-router to collect extended router
information.
extended-switch
Enter the keyword extended-switch to collect extended switch
information.
enable
Enter the keyword enable to enable global extended information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series