Reference Guide

sFlow | 1403
sflow extended-switch enable
c e s
Enable packing information on a switch only.
Syntax
sflow extended-switch enable
To disable packing information, use the no sflow extended-switch [enable] command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
FTOS 7.8.1.0 and later enhances the sflow implementation for real time traffic
analysis on the E-Series to provide extended gateway information in cases where the
destination IP addresses are learned by different routing protocols, and for cases
where the destination is reachable over ECMP.
Related
Commands
sflow polling-interval (Global)
c e s
Set the sFlow polling interval at a global level.
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
enable
Enter the keyword enable to enable global extended information.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
sflow extended-gateway enable Enable packing information on an extended gateway.
sflow extended-router enable Enable packing information on a router.
show sflow Display the sFlow configuration