Reference Guide

1404 |sFlow
www.dell.com | support.dell.com
Parameters
Defaults
20 seconds
Command Modes
CONFIGURATION
Command
History
Usage
Information
The polling interval for an interface is the maximum number of seconds between
successive samples of counters to be sent to the collector. This command changes the
global default counter polling (20 seconds) interval. You can configure an interface to
use a different polling interval.
Related
Commands
sflow polling-interval (Interface)
c e s
Set the sFlow polling interval at an interface (overrides the global-level setting.)
Syntax
sflow polling-interval interval value
To return to the default, use the no sflow polling-interval interval command.
Parameters
Defaults
The same value as the current global default counter polling interval
Command Modes
INTERFACE
Command
History
interval value
Enter the interval value in seconds.
Range: 15 to 86400 seconds
Default: 20 seconds
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
sflow polling-interval
(Interface)
Set the polling interval for an interface
interval value
Enter the interval value in seconds.
Range: 15 to 86400 seconds
Default: The global counter polling interval
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810