Reference Guide

1416 | Simple Network Management Protocol and Syslog
www.dell.com | support.dell.com
Command
History
snmp-server enable traps
c e s z
Enable SNMP traps.
Syntax
snmp-server enable traps [notification-type] [notification-option]
To disable traps, use the
no snmp-server enable traps [notification-type]
[
notification-option] command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
notification-type
Enter the type of notification from the list below:
•
bgp—Notification of changes in BGP process
•
ecfm — Notification of changes to ECFM
•
envmon—For Dell Force10, device notifications when an
environmental threshold is exceeded
•
isis — Notification of intermediate service traps.
•
lacp — Notification of changes to
•
snmp—Notification of RFC 1157 traps.
•
stp —Notification of state change in Spanning Tree protocol (RFC
1493)
•
vlt—Notification of virtual link trunking
•
vrrp—Notification of state change in a VRRP group
•
xstp—Notification of state change in MSTP (802.1s), RSTP
(802.1w), and PVST+
notification-option
For the envmon notification-type, enter one of the following optional
parameters:
• cam-utilization
•fan
• supply
• temperature
For the
snmp notification-type, enter one of the following optional
parameters:
• authentication
• coldstart
• linkdown
• linkup