Reference Guide

Simple Network Management Protocol and Syslog | 1419
Parameters
Defaults
As defined above
Command Modes
CONFIGURATION
Command
History
group_name
Enter a text string (up to 20 characters long) as the name of the
group.
Defaults: The following groups are created for mapping to read/write
community/security-names.
•
v1v2creadg — maps to a community/security-name with ro
permissions
•
1v2cwriteg — maps to a community/security-name rw
permissions
1 | 2c | 3
(OPTIONAL) Enter the security model version number (1, 2c, or 3).
•
1 is the least secure version
•
3 is the most secure of the security modes.
•
2c allows transmission of informs and counter 64, which allows
for integers twice the width of what is normally allowed.
Default:
1
auth
(OPTIONAL) Enter the keyword auth to specify authentication of a
packet without encryption.
noauth
(OPTIONAL) Enter the keyword noauth to specify no
authentication of a packet.
priv
(OPTIONAL) Enter the keyword priv to specify both authentication
and then scrambling of the packet.
read name
(OPTIONAL) Enter the keyword read followed by a name (a string
of up to 20 characters long) as the read view name.
Default: GlobalView is set by default and is assumed to be every
object belonging to the Internet (1.3.6.1) OID space.
write name
(OPTIONAL) Enter the keyword write followed by a name (a string
of up to 20 characters long) as the write view name.
notify name
(OPTIONAL) Enter the keyword notify followed by a name (a string
of up to 20 characters long) as the notify view name.
Note: This parameter must be enabled on the receiver for traps to be
received.
access access-list name
(Optional) Enter the standard IPv4 access list name (a string up to 16
characters long).
ipv6 access-list -name
(Optional) Enter the keyword ipv6 followed by the IPv6 access list
name (a string up to 16 characters long)
access-list-name ipv6
access-list-name
(Optional) Enter both an IPv4 and IPv6 access list name.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.10.2 Added
access parameter support
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series