Reference Guide

142 | Control and Monitoring
www.dell.com | support.dell.com
show tech-support (C-Series and E-Series)
c e
Display, or save to a file, a collection of data from other show commands, the
information necessary for Force10 Networks technical support to perform
troubleshooting.
Syntax
show tech-support [linecard 0-6 | page] | {display | except | find | grep | no-more | save}
Parameters
Command Modes
EXEC Privilege
Command
History
Example
(C-Series)
FTOS#show tech-support page
----------------------------------- show version -------------------------------
Dell Force10 Networks Real Time Operating System Software
Dell Force10 Operating System Version: 1.0
Dell Force10 Application Software Version: FTOS 7.5.1.0
Copyright (c) 1999-2007 by Force10 Networks, Inc.
Build Time: Tue Sep 12 15:39:17 IST 2006
Build Path: /sites/maa/work/sw//C-SERIES/SW/SRC
Dell Force10 uptime is 18 minutes
System image file is "/work/sw/IMAGES/Chassis/C300-ODC-2/FTOS-CS.bin"
Chassis Type: C300
Control Processor: IBM PowerPC 750FX (Rev D2.2) with 1073741824 bytes of memory.
128K bytes of non-volatile configuration memory.
1 Route Processor/Switch Fabric Module
2 48-port GE 10/100/1000Base-T line card with RJ45 interface (CB)
1 FastEthernet/IEEE 802.3 interface(s)
96 GigabitEthernet/IEEE 802.3 interface(s)
show hardware stack-unit Display the data plane and management plane input and output
statistics of a particular stack member.
stack-unit priority Configure the ability of an S-Series switch to become the
management unit of a stack.
linecard 0-6 (OPTIONAL) Enter the keyword linecard followed by the linecard number to
view information relating to a specific linecard.
page
(OPTIONAL) Enter the keyword page to view 24 lines of text at a time.
Press the SPACE BAR to view the next 24 lines.
Press the ENTER key to view the next line of text.
display, except,
find, grep,
no-more
If you use the pipe command ( | ), then enter one of these keywords to filter
command output. Refer to Filtering show Commands in the CLI Basics
chapter for details on filtering commands.
save
Enter the save keyword (following the pipe) to save the command output.
flash: Save to local flash drive (flash://filename (max 20 chars) )
slot0: Save to local file system (slot0://filename (max 20 chars) )
Version 7.8.1.0 Introduced save to file options
Version 7.5.1.0 Introduced on C-Series
Version 6.5.4.0 Show clock included in display on E-Series