Reference Guide

1424 | Simple Network Management Protocol and Syslog
www.dell.com | support.dell.com
Parameter
Defaults
The IP address assigned to the management interface is the default.
Command Modes
CONFIGURATION
Command
History
Usage
Information
For this snmp-server trap-source command to be enabled, you must configure an IP
address on the interface and enable the interface configured as an SNMP trap source.
Related
Commands
snmp-server user
c e s z
Configure a new user to an SNMP group.
Syntax
snmp-server user
name {group_name remote ip-address udp-port port-number} [1 | 2c | 3]
[
encrypted] [auth {md5 | sha} auth-password] [priv des56 priv password] [access
access-list-name | ipv6
access-list-name | access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the
no snmp-server user name
{group_name remote ip-address udp-port port-number} [1 | 2c | 3] [encrypted] [auth
{
md5 | sha} auth-password] [priv des56 priv password] [access access-list-name | ipv6
access-list-name | access-list-name ipv6 access-list-name] command.
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a SONET interface, enter the keyword
sonet followed by the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
• For VLAN interface, enter the keyword
vlan followed by a number
from 1 to 4094.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.12.0 Added description of keyword
vlan
Version 8.3.7.0 Introduced on S4810
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
snmp-server
community
Set the community string.