Reference Guide

Simple Network Management Protocol and Syslog | 1425
Parameters
Defaults
As above
Command Modes
CONFIGURATION
name
Enter the name of the user (not to exceed 20 characters), on the host, that
connects to the agent.
group_name
Enter a text string (up to 20 characters long) as the name of the group.
Defaults: The following groups are created for mapping to read/write
community/security-names.
•
v1v2creadu — maps to a community with ro (read only)
permissions
•
1v2cwriteu — maps to a community rw (read/write) permissions
remote ip-address
Enter the keyword remote followed by the IP address that identifies the
copy of the SNMP on the remote device.
udp-port port-number
Enter the keyword udp-port followed by the UDP (User Datagram
Protocol) port number on the remote device.
Range: 0 to 65535.
Default: 162
1 | 2c | 3
(OPTIONAL) Enter the security model version number (1, 2c, or 3).
•
1 is the least secure version
•
2c allows transmission of informs and counter 64, which allows for
integers twice the width of what is normally allowed.
•
3 is the most secure of the security modes.
Default:
1
encrypted
(OPTIONAL) Enter the keyword encrypted to specify the password
appear in encrypted format (a series of digits, masking the true characters
of the string).
auth
(OPTIONAL) Enter the keyword auth to specify authentication of a
packet without encryption.
md5 | sha
(OPTIONAL) Enter the keyword md5 or sha to designate the
authentication level.
md5 — Message Digest Algorithm
sha — Secure Hash Algorithm
auth-password
(OPTIONAL) Enter a text string (up to 20 characters long) password that
will enable the agent to receive packets from the host.
Minimum: 8 characters long
priv des56
(OPTIONAL) Enter the keyword priv des56 to initiate a privacy
authentication level setting using the CBC-DES privacy authentication
algorithm (
des56).
priv password
(OPTIONAL) Enter a text string (up to 20 characters long) password that
will enables the host to encrypt the contents of the message it sends to the
agent.
Minimum: 8 characters long
access
access-list-name
(Optional) Enter the keyword access followed by the standard IPv4
access list name (a string up to 16 characters long).
ipv6 access-list-name
(Optional) Enter the keyword ipv6 followed by the IPv6 access list name
(a string up to 16 characters long)
access-list-name ipv6
access-list-name
(Optional) Enter both an IPv4 and IPv6 access list name.