Reference Guide

Simple Network Management Protocol and Syslog | 1431
Related
Commands
logging
c e s z
Configure an IP address or host name of a Syslog server where logging messages will
be sent. Multiple logging servers of both IPv4 and/or IPv6 can be configured.
Syntax
logging
{ipv4-address | ipv6-address | hostname}
To disable logging, enter
no logging.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Related
Commands
logging buffered
c e s z
Enable logging and specify which messages are logged to an internal buffer. By
default, all messages are logged to the internal buffer.
Syntax
logging buffered
[level] [size]
To return to the default values, enter
default logging buffered. To disable logging
stored to an internal buffer, enter
no logging buffered.
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging trap Limit messages logged to the Syslog servers based on severity.
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) address.
hostname
Enter the name of a host already configured and recognized by the switch.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 8.4.1.0 Added support for IPv6.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging on Enables the logging asynchronously to logging buffer, console, Syslog server,
and terminal lines.
logging trap Enables logging to the Syslog server based on severity.