Reference Guide

Simple Network Management Protocol and Syslog | 1437
To disable this command and return to the default setting, enter no logging
source-interface
.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
Syslog messages contain the IP address of the interface used to egress the router. By
configuring the logging source-interface command, the Syslog packets contain the IP
address of the interface configured.
Related
Commands
logging synchronous
c e s z
Synchronize unsolicited messages and FTOS output.
interface
Enter the following keywords and slot/port or number information:
For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
For Loopback interfaces, enter the keyword
loopback followed by a number
from zero (0) to 16383.
For the management interface on the RPM, enter the keyword
ManagementEthernet followed by the slot/port information. The slot range
is 0-1 and the port range is 0.
For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512
for ExaScale.
For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
For VLAN interface, enter the keyword
vlan followed by a number from 1 to
4094.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging Enable the logging to another device.