Reference Guide

S-Series Stacking Commands | 1449
Parameters
Defaults
0
Command Modes
CONFIGURATION
Command
History
Related
Commands
stack-unit provision
s
Pre-configure a logical stacking ID of a switch that will join the stack. This is an
optional command that is executed on the management unit.
Syntax
stack-unit 0-11 provision {S25N|S25P|S25V|S50N|S50V|S4810|S4820T}
Parameters
Defaults
When this value is not set, a switch joining the stack is given the next available
sequential stack member
identifier.
Command Modes
CONFIGURATION
Command
History
Related
Commands
0-7
Enter the stack member unit identifier, from 0 to 7, of the switch on which you want to
set the management priority.
1-14
This preference parameter allows you to specify the management priority of one backup
switch over another, with 0 the lowest priority and 14 the highest.
The switch with the highest priority value will be chosen to become the management unit
if the active management unit fails or on the next reload.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series,
S4810 and S4820T)
Display the current status of all stack members or a specific member.
0-11
Enter a stack member identifier, from 0 to 11, of the switch that you want to
add to the stack.
S25N|S25P|S25V|
S50N
|S50V|S4810
|S4820T
Enter the S-Series model identifier of the switch to be added as a stack
member. This identifier is also referred to as the provision type.
Version 8.3.19.0 Introduced on S4820T
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series,
S4810 and S4820T)
Display the current status of all stack members or a specific member.