Reference Guide

1450 | S-Series Stacking Commands
www.dell.com | support.dell.com
stack-unit renumber
s
Change the stack member ID of any stack member or a stand-alone S-Series.
Syntax
stack-unit 0-11 renumber 0-11
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members
are renumbered, only that specific unit will reset and come up with the new unit
number.
Example
FTOS#stack-unit 5 renumber 6
Renumbering will reset the unit.
Warning: Interface configuration for current unit will be lost!
Proceed to renumber [confirm yes/no]:
Related
Commands
stack-unit stack-group
Configure the stacking unit and stacking group by specifying an ID when adding
units to a stack to ensure the unit is assigned to the correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
Use no stack-unit unit-id stack-group stack-id to remove the current stack group
configuration.
0-11
The first instance of this value is the stack member unit identifier of the
switch that you want add to the stack.
Range: 0-11.
The second instance of this value is the desired new unit identifier number.
Version 8.3.19.0 Introduced on S4820T
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
reset stack-unit Reset the designated S-Series stack member.
show system (S-Series,
S4810 and S4820T)
Display the current status of all stack members or a specific member.