Reference Guide

Storm Control | 1457
Example
(E-Series)
FTOS#show storm-control unknown-unicast gigabitethernet 11/1
Unknown-unicast storm control configuration
Interface Direction Percentage Wred Profile
--------------------------------------------------------------
Gi 11/1 Ingress 5.9 -
Gi 11/1 Egress 5.7 w8
FTOS#
Example
(C-Series)
FTOS#show storm-control unknown-unicast gigabitethernet 3/0
Unknown-unicast storm control configuration
Interface Direction Packets/Second
-----------------------------------------------
Gi 3/0 Ingress 1000
FTOS#
storm-control broadcast (Configuration)
c e s
Configure the percentage of broadcast traffic allowed in or out of the network.
Syntax
storm-control broadcast [percentage decimal_value in | out] | [wred-profile name]]
[
packets_per_second in]
To disable broadcast rate-limiting, use the storm-control broadcast [percentage
decimal_value in | out] | [wred-profile name]] [packets_per_second in] command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf)
Command
History
percentage
decimal_value in | out
E-Series Only: Enter the percentage of broadcast traffic allowed in or
out of the network. Optionally, you can designate a decimal value
percentage, for example, 55.5%.
Percentage: 0 to 100
0 % blocks all related traffic
100% allows all traffic into the interface
Decimal Range: .1 to .9
wred-profile name
E-Series Only: (Optionally) Enter the keyword wred-profile followed
by the profile name to designate a wred-profile.
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of broadcast
traffic allowed into the network.
Range: 0 to 33554431
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810