Reference Guide

Storm Control | 1459
storm-control multicast (Configuration)
c s
Configure the packets per second (pps) of multicast traffic allowed in to the C-Series
and S-Series networks only.
Syntax
storm-control multicast packets_per_second in
To disable storm-control for multicast traffic into the network, use the no
storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf)
Command
History
Usage
Information
Broadcast traffic (all 0xFs) should be counted against broadcast storm control meter,
not against the multicast storm control meter. It is possible, however, that some
multicast control traffic may get dropped when storm control thresholds are
exceeded.
storm-control multicast (Interface)
c s
Configure the percentage of multicast traffic allowed on an C-Series or S-Series
interface (ingress only) network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
Defaults
No default behavior or values
Command Modes
INTERFACE (conf-if-interface-slot/port)
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of multicast
traffic allowed into the network followed by the keyword
in.
Range: 0 to 33554431
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on C-Series and S-Series only
packets_per_second
in
C-Series and S-Series Only: Enter the packets per second of broadcast
traffic allowed into the network.
Range: 0 to 33554431