Reference Guide

Spanning Tree Protocol (STP) | 1465
Command
History
Usage
Information
When you enable debug spanning-tree bpdu for multiple interfaces, the software only
sends information on BPDUs for the last interface specified.
Related
Commands
description
c e s
Enter a description of the Spanning Tree
Syntax
description {description}
To remove the description from the Spanning Tree, use the
no description
{
description} command.
Parameters
Defaults
No default behavior or values
Command Modes
SPANNING TREE (The prompt is “config-stp”.)
Command
History
Related
Commands
disable
c e s
Disable Spanning Tree Protocol globally on the switch.
Syntax
disable
To enable Spanning Tree Protocol, enter no disable.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
protocol spanning-tree Enter SPANNING TREE mode on the switch.
description
Enter a description to identify the Spanning Tree (80 characters maximum).
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
pre-7.7.1.0 Introduced
protocol spanning-tree Enter SPANNING TREE mode on the switch.