Reference Guide

1468 | Spanning Tree Protocol (STP)
www.dell.com | support.dell.com
Command
History
Related
Commands
protocol spanning-tree
c e s
Enter the SPANNING TREE mode to enable and configure the Spanning Tree group.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, enter no protocol spanning-tree stp-id command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example
FTOS(conf)#protocol spanning-tree 0
FTOS(config-stp)#
Usage
Information
STP is not enabled when you enter the SPANNING TREE mode. To enable STP
globally on the switch, enter no disable from the SPANNING TREE mode.
Related
Commands
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
forward-delay Change the wait time before STP transitions to the Forwarding state.
hello-time Change the time interval between BPDUs.
stp-id
Enter zero (0). FTOS supports one Spanning Tree group, group 0.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
disable Disable Spanning Tree group 0. To enable Spanning Tree group 0, enter no disable.