Reference Guide

S4810 and S4820T u-Boot | 1493
54
S4810 and S4820T u-Boot
Overview
All commands in this chapter are in u-Boot. These commands are supported on the
Dell Force10 and
platforms only.
To access this mode, hit any key when the following line appears on the console
during a system boot:
Hit any key to stop autoboot:
You enter u-Boot immediately, as indicated by the => prompt.
Commands
• printenv
• reset
• save
• setenv
printenv
Display the current system boot variable and other system settings.
Syntax
printenv
Command Modes
uBoot
Note: This chapter discusses only a few commands available in uBoot. The
commands included here are those that are comparable to those found in the Boot
User mode on other S-Series systems.
Note: You cannot use the Tab key to complete commands in this mode.