Reference Guide

1506 | Uplink Failure Detection (UFD)
www.dell.com | support.dell.com
Defaults
None
Command Modes
UPLINK-STATE-GROUP
Command
History
Usage
Information
You can assign physical port or port-channel interfaces to an uplink-state group.
You can assign an interface to only one uplink-state group. Each interface assigned to
an uplink-state group must be configured as either an upstream or downstream
interface, but not both.
You can assign individual member ports of a port channel to the group. An
uplink-state group can contain either the member ports of a port channel or the port
channel itself, but not both.
To delete an uplink-state group, enter the no upstream interface command.
Related
Commands
Example
FTOS(conf-uplink-state-group-16)# upstream gigabitethernet 1/10-15
FTOS(conf-uplink-state-group-16)#
Version 8.3.19.0 Introduced on S4820T
Version 8.3.12.0 Introduced on S4810
Version 8.4.2.3 Introduced on the S-Series S50.
downstream Assign a port or port-channel to the uplink-state group as a downstream
interface.
uplink-state-group Create an uplink-state group and enabling the tracking of upstream
links.