Reference Guide

1510 | VLAN Stacking
www.dell.com | support.dell.com
Related
Commands
member
c e s
Assign a Stackable VLAN access or trunk port to a VLAN. The VLAN must contain
the vlan-stack compatible command in its configuration.
Syntax
member
interface
To remove an interface from a Stackable VLAN, use the
no member interface
command.
Parameters
Defaults
Not configured.
Command Mode
CONF-IF-VLAN
Command
History
Usage
Information
You must enable the Stackable VLAN (using the vlan-stack compatible command) on
the VLAN prior to adding a member to the VLAN.
Related
Commands
show interface dei-honor
c s
Display the dei honor configuration.
Syntax
show interface dei-honor
[interface slot/port | linecard number port-set number]
dei enable
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed
by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabyte Ethernet interface, enter the keyword
fortyGigE followed by
the slot/port information.
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.6.1.0 Support added for C-Series and S-Series
E-Series original Command
vlan-stack compatible Enable Stackable VLAN on a VLAN.