Reference Guide

1512 | VLAN Stacking
www.dell.com | support.dell.com
stack-unit stack-group
Configure stacking group specified by ID.
Syntax
[no] stack-unit unit-id stack-group stack-group-id
Parameters
Defaults
N/A
Command Mode
CONFIGURATION
Command
History
Usage
Information
vlan-stack access
c e s
Specify a Layer 2 port or port channel as an access port to the Stackable VLAN
network.
Syntax
vlan-stack access
To remove access port designation, enter no vlan-stack access.
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
unit-id
Enter the stack unit ID.
stack-group-id
Enter the stack group ID. Range is 0 to 16.
[no]
Use no stack-unit unit-id stack-group stack-id to remove the
current stack group configuration.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.10.2 Introduced on S4810
Warning: The following message is displayed to confirm the command:
All non-default configurations on the related member ports
ports (<ports listed here>) will be removed. Do you want to
continue (y/n)?
If “y” is entered, all non-default configurations on any member ports of the current stack group
will be removed when the unit is rebooted.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduced on the E-Series ExaScale