Reference Guide

VLAN Stacking | 1513
Usage
Information
Prior to enabling this command, you must enter the switchport command to place the
interface in Layer 2 mode.
To remove the access port designation, the port must be removed (using the
no
member
interface command) from all Stackable VLAN enabled VLANs.
vlan-stack compatible
c e s
Enable the Stackable VLAN feature on a VLAN.
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, enter no vlan-stack compatible.
Defaults
Not configured.
Command Modes
CONF-IF-VLAN
Command
History
Usage
Information
You must remove the members prior to disabling the Stackable VLAN feature.
To view the Stackable VLANs, use the
show vlan command in the EXEC Privilege
mode. Stackable VLANs contain members, designated by the M in the Q column of
the command output.
Example
FTOS#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Gi 13/13
M Gi 13/0-2
3 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/3
4 Active M Po1(Gi 13/14-15)
M Gi 13/18
Version 7.6.1.0 Support added for C-Series and S-Series
E-Series original Command
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Introduced on the E-Series ExaScale
Version 7.6.1.0 Support added for C-Series and S-Series
E-Series original Command