Reference Guide

Control and Monitoring | 153
Command
History
upload trace-log
c e
Upload trace log files from the three CPUs (cp, rp1, and rp2)
Syntax
upload trace-log {cp {cmd-history | hw-trace | sw-trace}| rp1 {cmd-history | hw-trace |
sw-trace}| rp2 {cmd-history | hw-trace | sw-trace}}
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
The log information is uploaded to flash:/TRACE_LOG_DIR
virtual-ip
c e
Configure a virtual IP address for the active management interface. Virtual addresses
can be configured both for IPv4 and IPv6 independently.
Syntax
virtual-ip {ipv4-address | ipv6-address}
Parameters
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
cp | rp1 | rp2 Enter the keyword cp | rp1 | rp2 to upload the trace log from that
CPU.
cmd-history
(OPTIONAL) Enter the keyword cmd-history to upload the CPU’s
command history.
hw-trace
(OPTIONAL) Enter the keyword hw-trace to upload the CPU’s
hardware trace.
sw-trace
(OPTIONAL) Enter the keyword sw-trace to upload the CPU’s
software trace.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series and expanded to support command history, hardware
trace, and software trace logs
Version 6.1.1.0 Introduced on E-Series
{ipv4-address |
ipv6-address}
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::) of the
active management interface.