Reference Guide

1536 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
description
c e s
Configure a short text string describing the VRRP group.
Syntax
description text
To delete a VRRP group description, enter no description.
Parameters
Defaults
Not enabled.
Command Modes
VRRP
Command
History
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For Port Channel interface types, enter the keyword
port-channel followed by
the number:
C-Series and S-Series Range: 1 to 128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by the VLAN ID.
The VLAN ID range is from 1 to 4094.
vrrp-id
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all
Enter the keyword all to enable debugging of all VRRP groups.
bfd Enter the keyword
bfd to enable debugging of all VFFP BFD interactions
packets
Enter the keyword packets to enable debugging of VRRP control packets.
state
Enter the keyword state to enable debugging of VRRP state changes.
timer
Enter the keyword timer to enable debugging of the VRRP timer.
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
text
Enter a text string up to 80 characters long.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series