Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1537
disable
c e s
Disable a VRRP group.
Syntax
disable
To re-enable a disabled VRRP group, enter no disable.
Defaults
C and S-Series default: VRRP is enabled.
E-Series default: VRRP is disabled.
Command Modes
VRRP
Command
History
Usage
Information
To enable VRRP traffic, assign an IP address to the VRRP group using the
virtual-address command and enter
no disable.
Related
Commands
hold-time
c e s
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By
delaying the initialization of the VRRP MASTER, the new switch can stabilize its
routing tables.
Syntax
hold-time seconds
To return to the default value, enter no hold-time.
Parameters
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
virtual-address Specify the IP address of the Virtual Router.
seconds
Enter a number of seconds.
Range: 0 to 65535.
Default: zero (0) seconds.