Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1539
Parameters
Defaults
100
Command Modes
VRRP
Command
History
Usage
Information
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s
virtual address with same IP address as the interface’s primary IP address and change
the priority of the VRRP group to 255.
If you set the priority to 255 and the virtual-address is not equal to the interface’s
primary IP address, an error message appears.
show config
c e s
View the non-default VRRP configuration.
Syntax
show config [verbose]
Parameters
Command Modes
VRRP
Command
History
Example
FTOS(conf-if-vrid-4)#show con
vrrp-group 4
virtual-address 119.192.182.124
!
priority
Enter a number as the priority. Enter 255 only if the router’s virtual address is the
same as the interface’s primary IP address (that is, the router is the OWNER).
Range: 1 to 255
Default: 100
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
verbose
(OPTIONAL) Enter the keyword verbose to view all VRRP group configuration
information, including defaults.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series