Reference Guide

1544 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
VRRP
Command
History
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
A system message appears after you enter or delete the virtual-address command.
To guarantee that a VRRP group becomes MASTER, configure the VRRP group’s
virtual address with the same IP address as the interface’s primary IP address and
change the priority of the VRRP group to 255.
You can ping the virtual addresses configured in all VRRP groups.
vrrp delay minimum
Set the delay time for VRRP initialization after an interface comes up.
Syntax
vrrp delay minimum seconds
Parameters
Defaults
0
ip-address1
Enter an IP address of the virtual router in dotted decimal format.
The IP address must be on the same subnet as the interface’s primary IP
address.
...
ip-address12 (OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in
dotted decimal format. Separate the IP addresses with a space.
The IP addresses must be on the same subnet as the interface’s primary IP
address.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced support for telnetting to the VRRP group IP address assigned
using this command
pre-Version 6.2.1.1 Introduced on E-Series
seconds
Enter the number of seconds for the delay for VRRP initialization after an
interface becomes operational.
Range: 0 to 900 (0 indicates no delay)