Reference Guide

1546 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
You must save the configuration and reload the system for the delay timers to take
affect.
Related
Commands
vrrp-group
c e s
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per
interface.
Syntax
vrrp-group vrrp-id
Parameters
Defaults
Not configured.
Command Modes
INTERFACE
Command
History
Usage
Information
The VRRP group only becomes active and sends VRRP packets when a virtual IP
address is configured. When you delete the virtual address, the VRRP group stops
sending VRRP packets.
Related
Commands
IPv6 VRRP Commands
The IPv6 VRRP commands are:
• clear counters vrrp ipv6
• debug vrrp ipv6
• show vrrp ipv6
• vrrp-ipv6-group
The following commands apply to IPv4 and IPv6:
vrrp delay minimum Set the delay time for VRRP initialization after a line card reboot.
vrrp-id
Enter a number as the group ID.
Range: 1 to 255.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
virtual-address Assign up to 12 virtual IP addresses per VRRP group.