Reference Guide

1548 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
show vrrp ipv6
e c s
View the IPv6 VRRP groups that are active. If no VRRP groups are active, the FTOS
returns “No Active VRRP group.”
Syntax
show vrrp ipv6 [vrid] [interface] [brief]
interface Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
E-Series Range: 1 to 255 for TeraScale
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by the VLAN ID. The
VLAN ID range is from 1 to 4094.
vrid (OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all
Enter the keyword all to enable debugging of all VRRP groups.
bfd
Enter the keyword bfd to enable debugging of all VFFP BFD interactions
database
Enter the keyword database to display changes related to group, prefix, and
interface entries in the VRRP table.
packets
Enter the keyword packets to enable debugging of VRRP control packets.
state
Enter the keyword state to enable debugging of VRRP state changes.
timer
Enter the keyword timer to enable debugging of the VRRP timer.
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series.
Version 8.3.10.0 Introduced on S4180
Version 8.3.2.0 Introduced on E-Series TeraScale