Reference Guide

S-Series Debugging and Diagnostics | 1561
Related
Commands
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
The commands are:
• clear hardware stack-unit
• clear hardware system-flow
• hardware watchdog
• show hardware layer2 acl
• show hardware layer3
• show hardware stack-unit
• show hardware system-flow
clear hardware stack-unit
s
Clear statistics from selected hardware components.
Syntax
clear hardware stack-unit 0–7 {counters | unit 0–1 counters | cpu data-plane statistics |
cpu party-bus statistics | stack-port 0–52}
Parameters
buffer-profile
(Configuration)
Create a buffer profile that can be applied to an
interface.
stack-unit 0-7 Enter the keyword stack-unit followed by 0 to 7 to select a particular
stack member and then enter one of the following command options
to clear a specific collection of data.
counters
Enter the keyword counters to clear the counters on the selected
stack member.
unit 0–1 counters
Enter the keyword unit along with a port-pipe number, from 0 to 1,
followed by the keyword counters to clear the counters on the
selected port-pipe.
Note: S25 models (S25N, S25P, S25V, etc.) have only port-pipe 0.
cpu data-plane statistics
Enter the keywords cpu data-plane statistics to clear the data plane
statistics.
cpu party-bus statistics
Enter the keywords cpu party-bus statistics to clear the
management statistics.
stack-port 0–52
Enter the keyword stack-port followed by the port number of the
stacking port to clear the statistics of the particular stacking port.
Range: 0 to 52
Note: You can identify stack port numbers by physical inspection of
the rear modules. The numbering is the same as for the 10G ports.
You can also inspect the output of the
show system stack-ports
command.