Reference Guide

160 | 802.1ag
www.dell.com | support.dell.com
Syntax mep cross-check mep-id
Parameters
Defaults
None
Command Modes
ECFM DOMAIN
Command
History
mep cross-check enable
s
Enable cross-checking.
Syntax
mep cross-check enable
{port | vlan-id}
Parameters
Defaults
None
Command Modes
ECFM DOMAIN
Command
History
mep cross-check start-delay
s
Configure the amount of time the system waits for a remote MEP to come up before
the cross-check operation is started.
Syntax
mep cross-check start-delay
number
Parameters
Defaults
3 ccms
Command Modes
ETHERNET CFM
mep-id
Enter the MEP ID
Range: 1-8191
Version 8.3.19.0 Introduced on the S4820T
Version 8.3.7.0 Introduced on the S4810
Version 8.3.1.0 Introduced on S-Series
port
Down service with no VLAN association.
vlan-id
Enter the VLAN to apply the cross-check.
Version 8.3.19.0 Introduced on the S4820T
Version 8.3.7.0 Introduced on the S4810
Version 8.3.1.0 Introduced on S-Series
start-delay number
Enter a start-delay in seconds.
Range: 3-100 seconds