Reference Guide

Access Control Lists (ACL) | 189
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST
CONFIGURATION-EXTENDED-ACCESS-LIST
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command
History
Usage
Information
The remark command is available in each ACL mode. You can configure up to
4294967290 remarks in a given ACL.
The following example shows the use of the remark command twice within the
CONFIGURATION-STANDARD-ACCESS-LIST mode. Here, the same sequence
number was used for the remark and for an associated ACL rule. The remark will
precede the rule in the running-config because it is assumed that the remark is for the
rule with the same sequence number, or the group of rules that follow the remark.
Example
FTOS(config-std-nacl)#remark 10 Deny rest of the traffic
FTOS(config-std-nacl)#remark 5 Permit traffic from XYZ Inc.
FTOS(config-std-nacl)#show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
seq 5 permit 1.1.1.0/24
remark 10 Deny rest of the traffic
seq 10 Deny any
FTOS(config-std-nacl)#
Related
Commands
show config
c e s
Display the current ACL configuration.
Syntax
show config
Command Modes
CONFIGURATION-STANDARD-ACCESS-LIST
CONFIGURATION-EXTENDED-ACCESS-LIST
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Added support for C-Series
pre-Version 6.4.1.0 Introduced for E-Series
show config Display the current ACL configuration.