Reference Guide

CLI Basics | 19
Obtaining Help
As soon as you are in a command mode there are several ways to access help.
• To obtain a list of keywords at any command mode, do the following:
FTOS(conf-if)#
FTOS(conf-if-gi-0/0)#
FTOS(conf-if-te-0/0)#
FTOS(conf-if-fo-0/0)#
FTOS(conf-if-lo-0)#
FTOS(conf-if-nu-0)#
FTOS(conf-if-po-0)#
FTOS(conf-if-vl-0)#
FTOS(conf-if-so-0/0)#
FTOS(conf-if-ma-0/0)#
FTOS(conf-if-range)#
INTERFACE
FTOS(config-ext-nacl)#
FTOS(config-std-nacl)#
IP ACCESS LIST
FTOS(config-line-aux)#
FTOS(config-line-console)#
FTOS(config-line-vty)#
LINE
FTOS(config-ext-macl)#
FTOS(config-std-macl)#
MAC ACCESS LIST
FTOS(config-mon-sess)# MONITOR SESSION
FTOS(config-span)# STP
FTOS(config-mstp)# MULTIPLE SPANNING TREE
FTOS(config-pvst)# Per-VLAN SPANNING TREE Plus
FTOS(config-rstp)# RAPID SPANNING TREE
FTOS(config-gvrp)# PROTOCOL GVRP
FTOS(config-route-map)# ROUTE-MAP
FTOS(conf-nprefixl)# PREFIX-LIST
FTOS(conf-router_rip)# ROUTER RIP
FTOS(conf-redirect-list)# REDIRECT
FTOS(conf-router_bgp)# ROUTER BGP
FTOS(conf-router_ospf)# ROUTER OSPF
FTOS(conf-router_isis)# ROUTER ISIS
FTOS(conf-trace-acl)# TRACE-LIST
FTOS(config-vlt-domain) VLT DOMAIN
Table 2-1. Command Prompt and Corresponding Command Mode
Prompt CLI Command Mode