Reference Guide

238 | Access Control Lists (ACL)
www.dell.com | support.dell.com
If the sequence-number is configured, then the sequence-number is used as a tie breaker
for rules with the same order.
Related
Commands
Common MAC Access List Commands
The following commands are available within both MAC ACL modes (Standard and
Extended) and do not have mode-specific options.
c and s platforms support Ingress MAC ACLs only.
The following commands allow you to clear, display and assign MAC ACL
configurations.
• clear counters mac access-group
• mac access-group
• show mac access-lists
• show mac accounting access-list
clear counters mac access-group
c e s
Clear counters for all or a specific MAC ACL.
Syntax
clear counters mac access-group [mac-list-name]
Parameters
Command Modes
EXEC Privilege
Command
History
mac access-group
c e s
Apply a MAC ACL to traffic entering or exiting an interface.
Note: When ACL logging and byte counters are configured simultaneously, byte
counters may display an incorrect value. Configure packet counters with logging
instead.
deny Configure a filter to drop packets.
permit Configure a filter to forward packets.
mac-list-name
(OPTIONAL) Enter the name of a configured MAC access list.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series