Reference Guide

Access Control Lists (ACL) | 247
To remove this filter, you have two choices:
• Use the
no seq sequence-number command syntax if you know the filter’s
sequence number or
• Use the
no deny {any | host mac-address | mac-source-address
mac-source-address-mask
} {any | host mac-address | mac-destination-address
mac-destination-address-mask
} command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION-MAC ACCESS LIST-EXTENDED
any Enter the keyword any to drop all packets.
host mac-address Enter the keyword host followed by a MAC address to
drop packets with that host address.
mac-source-address
Enter the source MAC address in nn:nn:nn:nn:nn:nn
format.
mac-source-address-mask
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask, therefore, a
mask of ff:ff:ff:ff:ff:ff allows entries that do not match
and a mask of 00:00:00:00:00:00 only allows entries
that match exactly.
mac-destination-address
Enter the destination MAC address and mask in
nn:nn:nn:nn:nn:nn format.
mac-destination-address-mask
Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask, therefore, a
mask of ff:ff:ff:ff:ff:ff allows entries that do not match
and a mask of 00:00:00:00:00:00 only allows entries
that match exactly.
ethertype operator
(OPTIONAL) To filter based on protocol type, enter
one of the following Ethertypes:
•
ev2 - is the Ethernet II frame format.
•
llc - is the IEEE 802.3 frame format.
•
snap - is the IEEE 802.3 SNAP frame format.
count
(OPTIONAL) Enter the keyword count to count
packets processed by the filter.
byte
(OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword
log to
log the packets.
monitor
(OPTIONAL) Enter the keyword monitor when the rule
is describing the traffic that you want to monitor and the
ACL in which you are creating the rule will be applied
to the monitored interface. For details, refer to the
section “Flow-based Monitoring” in the Port
Monitoring chapter of the FTOS Configuration Guide.