Reference Guide

260 | Access Control Lists (ACL)
www.dell.com | support.dell.com
• If the next route map entry does not contain a continue clause, the route map
evaluates normally. If a match does not does not occur, the route map does not
continue and will fall through to the next sequence number, if one exists.
Set clause with Continue clause
If the route-map entry contains sets with the continue clause, then set actions is
performed first followed by the continue clause jump to the specified route map
entry.
• If a set actions occurs in the first route map entry and then the same set action
occurs with a different value in a subsequent route map entry, the last set of
actions overrides the previous set of actions with the same
set command.
• If
set community additive and set as-path prepend are configure, the communities
and AS numbers are pre-pended.
Related
Commands
description
c e s
Add a description to this route map.
Syntax
description {description}
Parameters
Defaults
No default behavior or values
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match as-path
c e s
Configure a filter to match routes that have a certain AS number in their BGP path.
Syntax
match as-path as-path-name
Parameters
Defaults
Not configured.
set community Specify a COMMUNITY attribute
set as-path Configure a filter to modify the AS path
description
Enter a description to identify the route map (80 characters maximum).
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 7.7.1.0 Introduced
route-map Enable a route map
as-path-name
Enter the name of an established AS-PATH ACL, up to 140 characters.