Reference Guide

262 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match ip address
c e s
Configure a filter to match routes based on IP addresses specified in an access list.
Syntax
match ip address prefix-list-name
Parameters
Defaults
Not configured.
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/
port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For the loopback interface, enter the keyword
loopback followed by a number from
zero (0) to 16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the
slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094, 1-2094
for ExaScale (can used IDs 1-4094).
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match ip address Redistribute routes that match an IP address.
match ip next-hop Redistribute routes that match the next-hop IP address.
match ip route-source Redistribute routes that match routes advertised by other routers.
match metric Redistribute routes that match a specific metric.
match route-type Redistribute routes that match a route type.
match tag Redistribute routes that match a specific tag.
prefix-list-name
Enter the name of configured prefix list, up to 140 characters.