Reference Guide

Access Control Lists (ACL) | 267
Related
Commands
route-map
c e s
Enable a route map statement and configure its action and sequence number. This
command also places you in the ROUTE-MAP mode.
Syntax
route-map map-name [permit | deny] [sequence-number]
Parameters
Defaults
Not configured
If no keyword (
permit or deny) is defined for the route map, the permit action is the
default.
Command Modes
CONFIGURATION
Command
History
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match interface Redistribute routes that match the next-hop interface.
match ip address Redistribute routes that match an IP address.
match ip next-hop Redistribute routes that match the next-hop IP address.
match ip route-source Redistribute routes that match routes advertised by other routers.
match metric Redistribute routes that match a specific metric.
match route-type Redistribute routes that match a route type.
map-name
Enter a text string of up to 140 characters to name the route map for easy
identification.
permit
(OPTIONAL) Enter the keyword permit to set the route map default as
permit.
If no keyword is specified, the default is
permit.
deny
(OPTIONAL) Enter the keyword deny to set the route map default as
deny.
sequence-number
(OPTIONAL) Enter a number to identify the route map for editing and
sequencing with other route maps. You are prompted for a sequence
number if there are multiple instances of the route map.
Range: 1 to 65535.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
Version 7.6.1.0 Support added for S-Series