Reference Guide

268 | Access Control Lists (ACL)
www.dell.com | support.dell.com
\
Example
FTOS(conf)#route-map dempsey
FTOS(config-route-map)#
Usage
Information
Use caution when you delete route maps because if you do not specify a sequence
number, all route maps with the same
map-name are deleted when you use no
route-map
map-name command.
Prior to 7.8.1.0, names are up to 16 characters long.
Related
Commands
set as-path
c e s
Configure a filter to modify the AS path for BGP routes.
Syntax
set as-path prepend as-number [... as-number]
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
Usage
Information
You can prepend up to eight AS numbers to a BGP route.
This command influences best path selection in BGP by inserting a tag or AS number
into the AS_PATH attribute.
Related
Commands
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
show config Display the current configuration.
prepend as-number Enter the keyword prepend followed by up to eight AS numbers to be
inserted into the BGP path information.
Range: 1 to 65535
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match as-path Redistribute routes that match an AS-PATH attribute.
ip as-path access-list Configure an AS-PATH access list.