Reference Guide

CLI Basics | 27
1. Verify that you are logged in to the CONFIGURATION mode.
2. Use the
ip redirect-list command. You must include a name for the Redirect-list.The
prompt changes to include (conf-redirect-list).
You can return to the CONFIGURATION mode by entering the exit command.
SPANNING TREE Mode
Use the STP mode to enable and configure the Spanning Tree protocol, as described
in Chapter 52, Spanning Tree Protocol (STP).
To enter STP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the
protocol spanning-tree stp-id command.
You can return to the CONFIGURATION mode by entering the exit command.
Per-VLAN SPANNING TREE Plus Mode
Use PVST+ mode to enable and configure the Per-VLAN Spanning Tree (PVST+)
protocol, as described in Chapter 41, Per-VLAN Spanning Tree Plus (PVST+).
To enter PVST+ mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the
protocol spanning-tree pvst command.
You can return to the CONFIGURATION mode by entering the exit command.
RAPID SPANNING TREE Mode
Use PVST+ mode to enable and configure the RSTP protocol, as described in
Chapter 45, Rapid Spanning Tree Protocol (RSTP).
To enter RSTP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the
protocol spanning-tree rstp command.
You can return to the CONFIGURATION mode by entering the exit command.
Note: The protocol is PVST+, but the plus sign is dropped at the CLI prompt