Reference Guide

Access Control Lists (ACL) | 275
If you configure the set next-hop command with the interface’s (either Loopback or
physical) IP address, the software declares the route unreachable.
Related
Commands
set origin
c e s
Configure a filter to manipulate the BGP ORIGIN attribute.
Syntax
set origin {igp | egp | incomplete}
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
set tag
c e s
Configure a filter to specify a tag for redistributed routes.
Syntax
set tag tag-value
Parameters
Defaults
Not configured
match ip next-hop Redistribute routes that match the next-hop IP address.
neighbor next-hop-self Configure the routers as the next hop for a BGP neighbor.
egp Enter the keyword egp to set routes originating from outside the local AS.
igp
Enter the keyword igp to set routes originating within the same AS.
incomplete
Enter the keyword incomplete to set routes with incomplete routing
information.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
tag-value
Enter a number as the tag.
Range: zero (0) to 4294967295.