Reference Guide

318 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Related
Commands
Command
History
bgp default local-preference
c e s
Change the default local preference value for routes exchanged between internal BGP
peers.
Syntax
bgp default local-preference value
To return to the default value, enter no bgp default local-preference.
Parameters
Defaults
100
Command Modes
ROUTER BGP
Usage
Information
The bgp default local-preference command setting is applied by all routers within the
AS. To set the local preference for a specific route, use the set local-preference
command in the ROUTE-MAP mode.
Related
Commands
Command
History
bgp enforce-first-as
c e s
Disable (or enable) enforce-first-as check for updates received from EBGP peers.
show ip bgp dampened-paths View the BGP paths
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
value
Enter a number to assign to routes as the degree of preference for those routes.
When routes are compared, the higher the degree of preference or local
preference value, the more the route is preferred.
Range: 0 to 4294967295
Default: 100
set local-preference Assign a local preference value for a specific route.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced on C-Series