Reference Guide

326 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx | tx}
To disable capture of the IPv4 BGP neighbor packet, use the
no capture bgp-pdu
neighbor
ipv4-address command.
Parameters
Defaults
Not configured.
Command Modes
EXEC Privilege
Related
Commands
Command
History
capture bgp-pdu max-buffer-size
c e s
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4
and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
Defaults
40960000 bytes.
Command Modes
EXEC Privilege
Related
Commands
Command
History
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both | rx | tx}
Enter the keyword direction and a direction— either rx for
inbound,
tx for outbound, or both.
capture bgp-pdu max-buffer-size Specify a size for the capture buffer.
show capture bgp-pdu neighbor Display BGP packet capture information
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.5.1.0 Introduced
100-102400000
Enter a size for the capture buffer.
capture bgp-pdu neighbor Enable capture of an IPv4 BGP neighbor packet.
capture bgp-pdu neighbor (ipv6) Enable capture of an IPv6 BGP neighbor packet.
show capture bgp-pdu neighbor Display BGP packet capture information for an IPv6 address
on the E-Series.
Version 8.3.19.0 Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.